Expose the bottom downspout opening divert the flow away from any landscape drain and then use a garden trowel to reach up into the opening and remove any clogged leaves and debris that could have accumulated there.
Best way to snake a clogged gutter.
If you can t reach it simply disassemble the downspout and remove the clog.
Turn on the water spigot wide open to create as much pressure as possible.
If the amount of water coming out is less than what is going in there is a blockage.
Use your garden hose to run water into the gutters and through the downspout to be certain that it is no longer clogged.
Turn the handle clockwise to extend the end of the auger.
Insert the end of the plumber s snake in the downspout until it meets resistance.
Remove the snake from the pipe.
Turn the handle counterclockwise if it becomes hard.
Run the snake as far into the pipe as far as you can.
Feed the snake from the top of the downspout until it hits the obstruction which will usually be found at a curve in the downspout pipe.
Run the snake into the opposite end of the drain if it was not long enough to go through the entire pipe from the other end.
If the clog is below grade it s the most difficult to clear and may require excavation.
Turn the hose on at full pressure to try to dislodge the clog.
Insert a garden hose in the downspout and turn on the water to flush out any debris.
Feed the hose up the downspout from the ground.
Place the end of a plumber s auger also known as a snake into the underground gutter.
To unclog a gutter downspout try your easiest options first.
Watch the end of the downspout for the clog to clear.
Gutters are a beacon to pests for more than one reason.
If the clog persists remove the hose and manually clear it using a plumbing snake.
But normally you will not have this problem.
If the water does not flow freely through the downspout use your plumbing snake to clear away the last of the stuck debris.
Turn the crank and work it back and forth to loosen the clog.
If the moisture and decaying organic matter in a clogged system isn t the primary draw then it s often the fact that gutters high above.
Run water into the opposite end of the pipe.